Our Radius Arm Nut Weld Plate Makes Your Life Easier
It sucks when youre upgrading the radius arms on your Can-Am Maverick R, and the tack-welded nuts break off and spin. Forget getting a wrench back there to hold them in place. Instead, get SuperATVs Radius Arm Nut Weld Plate. Its fully welded-on nuts wont pop loose, and its easy to get in place.

• Easy to install
• Fully welded
• Made of 3/16 steel

Built Better than Stock
The nuts on this weld plate are fully weldednot tack welded. Itll take more than a little too much juice with your impact to break them loose. Theyre hand welded to a 3/16 steel plate that slips into place easily so you can bolt them up and get going. Its easier to use and tougher than a standard radius rod nut retainer.

Features:

• Fully welded radius arm nuts
• Weld plate made of 3/16 steel
• Easy installationno drilling required

WARNING:This product can impact machine operation. Customer and/or user is responsible for ensuring that this product is compatible with their machine as currently configured, properly installed, and understands any impact this product has or might have on the machine’s operation.

California Proposition 65 Warning
WARNING:This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.

VEHICLE FITMENT

• Can-Am Maverick R : 2024+
• Can-Am Maverick R X : 2024+
• Can-Am Maverick R X RS : 2024+
• Can-Am Maverick R X RS with Smart-Shox : 2024+

INSTALLATION

Instructions – RA-CA-MAVR-T-NPW